Single Screw Extruder

Single Screw Extruder


The next generation Extruders. Screw and Barrel are designed and developed such a way that it can match specific raw material and end product requirement. Margo offers barrier screws resulting higher output, low melt temperature and good quality of melt.

Technical Specification





Models MS 25* MS 40 MS 50 MS 65 MS 75 MS 90 MS 120
Extruder Drive (kW) 3.7 7.5 15 30 37.5 60 110
Screw Dia (mm) 25 40 50 65 75 90 120
L.D. Ratio 24 : 1 26 : 1 26 : 1 26 : 1 26 : 1 26 : 1 26 : 1
Output ( Kg/Hour ) 4-5 18-20 36-40 90-100 12-130 170-190 300-320



Basic Screw

  • It allows high homogenous plasticizing less material slippage and higher output.
Grooved Feed System :


  • Higher productivity compared to conventional design.
  • Improved material conveying capacity.
  • Uniform throughout and melt temperature.
  • Pressure invariance.
 
Technical Specification :
Models MS 65G MS 65GH MS 90G MS 90GH MS 120G MS 120GH
Extruder Drive (kW) 60 75 110 150 180 315
Screw Dia (mm) 65 65 90 90 120 120
L.D. Ratio 30 : 1 30 : 1 30 : 1 30 : 1 30 : 1 30 : 1
Output ( Kg/Hour ) 170-190 200-220 325-350 430-450 500-550 750-800
 
DIE HEADS :
Margo provide most versatile spiral mandrel design Die.
 
Advantages
  • Short purging times.
  • Better inner pipe surfaces.
  • Uniform melt flow can be achieved yielding minimum wall thickness deviation.
  • Optimized back pressure allows a balance of compression & melt temperature control.
  • Consistent product quality for all pipe sizes.
 
Technical Specification

Models MSM 50 MSM 110 MSM 250 MSM 400 MSM 630
Pipe Range (mm) 12-50 20-120 63-250 90-400 225-630
Output Capacity (Kg/hr) 100 350 800 1100 1500




HDPE - Performance varies depending on pipe dimensions and type of material.
Smooth Bore Extruders for PVC Application are available.
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 


Single Screw / Twin Screw Extruders (For PVC/HDPE Pipes)